Building Regulations Part L to Help Reduce Carbon Emissions

Posted on November 20, 2008
Filed Under Make Money at Home |

Introduced in 2005 the new Building Regulations Part L has changed the scene as far as boilers are concerned. According to the new requirement, all boilers replaced or installed must be of high efficiency rating. This includes condensing and combination boilers which utilize a larger heat exchanger (or a secondary heat exchanger) to recoup some of the heat that would normally be released into the atmosphere with the exhaust gases. Since some of the energy can be reused, the boiler can generate the same amount of heat with less fuel.

The new requirements are much more demanding than previously in terms of the professional level of the system designer, the installer and the service engineer. The new systems are more integrated than old systems as all components are specifically designed to provide the right output (in terms of power) or demand the right input (such as in the case of heating controls). The engineer has to have good understanding in order to maximize the efficiency of the system.

Since Part L of the building regulation was introduced, domestic heating in the UK has seen a remarkable drop in the volume of carbon emissions that is generated annually. According to analysis conducted by the heating industry, a reduction of around 2.4 million tonnes of carbon was made since the new regulations were introduced. As a reference point, the analysis shows that if the industry did not adopt Part L and kept on relying on SEDBUK D rated boilers, the carbon emissions level would have increased by over one million tonnes since 2005.

At present there is still plenty of room for improvement in terms of the amount of carbon generated and emitted by domestic heating in the UK. There are around four million old boilers still installed around the country which have significantly lower efficiency compared to modern A rated boilers. Installing a modern A rated boiler as a replacement, would reduce their respective carbon emissions by around 30%. A typical home in the UK generates around 5 tonnes of carbon dioxide emissions every year. Overall carbon emitted from domestic heating sources is responsible for around 16% of the total UK national CO2 emissions.

The UK government is actively trying to encourage carbon reducing behaviour through legislation. The government introduced measures such as zero stamp duty on carbon neutral homes and instructed all home sellers to produce energy performance certificates as part of their home information pack. It is, nevertheless, important to put it in perspective, as there are very few carbon neutral homes in the country and the savings should be focused on the highly inefficient homes. There is additional criticism that home information packs only apply when homes are sold and make no carbon reduction related impact at other times.

Other levers that can be pulled to reduce carbon emissions from domestic heating in the UK are related to renewable and sustainable energy. The government plans to build around 3 million new homes between now and 2020. If just 10% of these new homes use solar thermal heating or heat pumps along with traditional (gas or oil) boilers, around 150,000 tonnes of carbon emissions would be saved annually.

There are several options for the government to reduce the carbon emissions from the UK housing stock and meet the challenging targets it set. It is important to note that any relevant plan would be met with a prepared and professional group of plumbing and heating companies that are investing in professional development and staff training for the new technologies.

Comments